Attaching Shaker Drawer Fronts. The hot glue will give you enough time to adjust your drawer to your marks. The bushings normally used on drawer fronts are 12 long which gives guidance for precise placement of the holes just be sure to hold the jig so that its resting on the Top Stop against the top of the drawer.
Cut another piece of 14 plywood to fit in the inset portion of the center panel. The hot glue will give you enough time to adjust your drawer to your marks. To build a 24 wide by 6 tall shaker style drawer front start by cutting two 6 pieces of 13 and two 19 12 pieces of 12.
Put four dabs of hot glue onto the drawer front and attach to your drawer.
If your dimensions are different youll have to adjust these measurements accordingly. Cut another piece of 14 plywood to fit in the inset portion of the center panel. Add the handle hardware completely and again check that the drawer front is level and the spacing is correct. If you dont have a finishing nailer you could just insert some screws from inside the drawers to fasten the drawer fronts.
